ON-VEHICLE INSPECTION PROCEDURE 1. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page
2. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) (a) Perform a diagnostic system check (see page
3. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED) (a) Replace the center airbag sensor. CAUTION: For removal and installation procedures of the center airbag sensor, be sure to follow the correct procedure. HINT: The center airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to the impact. |
Toyota Tundra Service Manual > Power Window Control System(w/o Jam Protection Function): How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use these procedures to troubleshoot the power window control system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. INSPECT BATTERY VOLTAGE Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery before procee ...
