Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Install the curtain shield airbag with the 10 bolts.

Torque:

11 N·m {110 kgf·cm, 8 ft·lbf}

NOTICE:

Do not twist the curtain shield airbag when installing it.

(b) Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

(a) Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for CrewMax) (see page )

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

4. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (see page ).

    Disposal

    On-vehicle Inspection

    See More:

    Toyota Tundra Service Manual > Meter / Gauge System: Last Communication With Navigation ECU (U0163)
    DESCRIPTION The combination meter assembly communicates with the navigation receiver assembly via the CAN line. DTC Code DTC Detection Condition Trouble Area U0163 When either of following conditions is detected: IG voltage 10.5 V or more No communication with navigation receiver assembly continues ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2023 Copyright www.ttundra.com
    0.0215