Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Install the curtain shield airbag with the 8 bolts.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

NOTICE:

Do not twist the curtain shield airbag when installing it.

(b) Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

4. CHECK SRS WARNING LIGHT

Click here

    Disposal

    On-vehicle Inspection

    See More:

    Toyota Tundra Service Manual > Tire Pressure Warning System: Initialization
    INITIALIZATION NOTICE: Initialization can be confirmed through the tire pressure warning light. If the ignition switch is turned off during initialization, the tire pressure warning ECU and receiver memorizes that initialization was being performed. Therefore, it is not necessary to perform the init ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.033