Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (see page ).

(b) With the curtain shield airbag installed on the vehicle, perform a visual check. If any of the defects mentioned below are present, replace the curtain shield airbag with a new one:

Cuts, minute cracks or marked discoloration on the curtain shield airbag.

2. CHECK CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (see page ).

(b) With the curtain shield airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the curtain shield airbag with a new one:

  • Cuts, minute cracks or marked discoloration on the curtain shield airbag.
  • Cracks or other damage to the connectors.

    CAUTION:

    For removal and installation procedures of the curtain shield airbag, be sure to follow the correct procedure.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Sfi System: Secondary Air Injection System Control "A" Circuit (P0418,P0419)
    DESCRIPTION Refer to DTC P0412 (See page ). DTC No. DTC Detection Condition Trouble Area P0418 P0419 After cold engine start, all of following conditions met (2 trip detection logic): Secondary Air Injection (AIR) system not operating (air pump OFF, Air Switching Valve [ASV] OFF) Diagnostic signal f ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0102