INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(b) Attach the 2 claws to install the DLC3. (c) Install the 4 bolts to install the instrument panel airbag. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
3. INSTALL INSTRUMENT SIDE PANEL LH
4. INSTALL COWL SIDE TRIM BOARD LH
5. INSTALL FRONT DOOR SCUFF PLATE LH
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 7. CHECK SRS WARNING LIGHT (a) Check the SRS warning light (See page |
Toyota Tundra Service Manual > Parking Brake Assembly: Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE REAR WHEEL LH 2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH (a) Remove the 2 bolts and disconnect the rear disc brake cylinder. NOT ...