Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 1 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag.

2. CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 1 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag with a new one:

  • Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag.
  • Cracks or other damage to the connector.
  • Deformation or cracks on the instrument panel reinforcement.

CAUTION:

For removal and installation procedures of the lower No. 1 instrument panel airbag, be sure to follow the correct procedure.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Vehicle Stability Control System: Center Differential Lock Circuit (C1340)
    DESCRIPTION The skid control ECU monitors the 2WD/4WD state from both the 4 wheel drive control ECU and the A.D.D. detection switch. DTC No. Detection Item DTC Detection Condition Trouble Area C1340 Center Differential Lock Circuit On a 4WD vehicle, a normal A.D.D. detection switch signal is input v ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0183