REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE FRONT DOOR SCUFF PLATE LH Click here 4. REMOVE COWL SIDE TRIM BOARD LH Click here 5. REMOVE INSTRUMENT SIDE PANEL LH Click here 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Click here 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY CAUTION: When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward. (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal.
(d) Detach the 2 claws and disconnect the DLC3. (e) Disconnect the connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. |
Toyota Tundra Service Manual > Automatic Transmission System: 1-2 Shift (1-2 Shift Valve) (P0781)
DESCRIPTION The 1-2 shift valve performs shifting to 1st gear and other gears. When shifting to 2nd and 4th gears is impossible, or when the ECM directs the transmission to switch to 5th or 6th gear and the engine overruns (clutch slips), this DTC is stored. DTC Code DTC Detection Condition Trouble ...