ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE NOT INVOLVED IN COLLISION)
(b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one: Cuts, minute cracks or marked discoloration on the front seatback around the front seat airbag assembly LH. 2. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(b) With the front seat airbag assembly LH removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat airbag assembly LH with a new one:
|
Toyota Tundra Service Manual > Front Drive Shaft Assembly(for 4wd): Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE NO. 1 ENGINE UNDER COVER 3. DRAIN DIFFERENTIAL OIL 4. DISCONNECT FRONT SPEED SENSOR LH (a) Disconnect the front speed ...