Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Vehicle Interior / Supplemental Restraint Systems / Seat Position Sensor / Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

(a) for Manual Seat:

(See page )

(b) for Power Seat:

(See page )

2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

3. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)

4. REMOVE SEAT POSITION AIRBAG SENSOR

(a) for Manual Seat:

(1) Disconnect the connector.

(2) Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor.

(b) for Power Seat:

(1) Disconnect the connector.

(2) Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor.
    On-vehicle Inspection

    Side Airbag Sensor(for Crewmax)

    See More:

    Toyota Tundra Service Manual > Exterior: Fender Liner(for Rear Side)
    Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL REAR WHEEL HOUSE LINER LH (a) Install the rear wheel house liner LH with 22 new grommets. ( ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0121