Toyota Tundra Service Manual: Security Horn Assembly

Toyota Tundra Service Manual / Vehicle Interior / Theft Deterrent / Security Horn Assembly

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT SECURITY HORN ASSEMBLY

(a) Apply battery voltage and check operation of the horn.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 1

Battery negative (-) → Horn bracket

Horn sounds

If the result is not as specified, replace the security horn assembly.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL SECURITY HORN ASSEMBLY

(a) Install the security horn assembly with the bolt.

(b) Connect the connector.

Removal

REMOVAL

PROCEDURE

1. REMOVE SECURITY HORN ASSEMBLY

(a) Disconnect the connector.

(b) Remove the bolt and security horn assembly.

Glass Breakage Sensor(for Floor Shift Type)

Theft Deterrent System

See More:

Toyota Tundra Service Manual > Can Communication System: Check Bus 2 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and termin ...

Toyota Tundra Service Manual: Security Horn Assembly

Glass Breakage Sensor(for Floor Shift Type)

Theft Deterrent System

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual