INSTALLATION PROCEDURE 1. INSTALL BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY (a) Attach the 2 claws to install the back door power window regulator switch assembly. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
3. INSTALL LOWER CENTER INSTRUMENT COVER (for Column Shift Type)
4. INSTALL INSTRUMENT SIDE PANEL LH
5. INSTALL COWL SIDE TRIM BOARD LH
6. INSTALL FRONT DOOR SCUFF PLATE LH
|
Toyota Tundra Service Manual > High Beam Main Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition If the result is not as specified, replace the auto high beam switch. 6 ...
