INSTALLATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (a) Attach the 3 claws to install the rear No. 2 speaker assembly to the rear door trim board sub-assembly. 2. INSTALL REAR NO. 1 SPEAKER ASSEMBLY (a) Connect the connector. Text in Illustration
(b) Install the rear No. 1 speaker assembly with the 3 screws. NOTICE: Do not touch the cone part of the speaker. HINT: Install the screws in the order shown in the illustration. 3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
4. INSTALL REAR DOOR ARMREST COVER LH 5. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
7. INSTALL REAR DOOR FRAME GARNISH LH
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Calibration
CALIBRATION DESCRIPTION (a) Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Replacement Part or Procedure Necessary Procedures Skid control ECU (brake actuator assembly) Perform system variant learning and accele ...