INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Attach the 6 guides and 2 claws to install the steering pad switch assembly. (b) Install the 4 screws. (c) Connect each connector. 2. INSTALL STEERING PAD Click here 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER Click here 4. INSTALL LOWER NO. 2 STEERING WHEEL COVER Click here 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 6. INSPECT STEERING PAD Click here 7. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Service Manual > Power Seat Switch(w/o Seat Position Memory System): Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See pa ...
