INSTALLATION PROCEDURE 1. INSTALL STEERING ANGLE SENSOR 2. INSTALL SPIRAL CABLE SUB-ASSEMBLY 3. INSTALL UPPER STEERING COLUMN COVER 4. INSTALL LOWER STEERING COLUMN COVER 5. ADJUST SPIRAL CABLE 6. INSTALL STEERING WHEEL ASSEMBLY 7. INSTALL STEERING PAD 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 11. CHECK SRS WARNING LIGHT (a) Check the SRS warning light (See page
|
Toyota Tundra Service Manual > Sfi System: Brake Switch "B" Circuit High (P0724)
DESCRIPTION The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signal to the ECM. Then the ECM cancels the operation of the lock-up clutch while braking ...
