REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. 3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 4. REMOVE LOWER NO. 3 STEERING WHEEL COVER 5. REMOVE LOWER NO. 2 STEERING WHEEL COVER 6. REMOVE STEERING PAD 7. REMOVE STEERING WHEEL ASSEMBLY 8. REMOVE LOWER STEERING COLUMN COVER 9. REMOVE UPPER STEERING COLUMN COVER 10. REMOVE SPIRAL CABLE SUB-ASSEMBLY 11. REMOVE STEERING ANGLE SENSOR |
Toyota Tundra Service Manual > 1ur-fe Engine Control: A/f Sensor Heater Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE INTEGRATION RELAY 2. INSPECT INTEGRATION RELAY (A/F) NOTICE: Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the ...
