Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Brake / Brake / Front Brake / Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT DISC

(a) Align the matchmarks, and then install the front disc.

HINT:

When replacing the front disc with a new one, select the installation position where the front disc has the smallest runout.

2. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

(a) Install the disc brake caliper with 2 new bolts.

Torque:

180 N·m {1835 kgf·cm, 133 ft·lbf}

3. CONNECT NO. 7 FRONT BRAKE TUBE

(a) Using a union nut wrench, connect the front brake tube.

Torque:

15 N·m {155 kgf·cm, 11 ft·lbf}

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page ).

4. INSTALL FRONT DISC BRAKE PAD KIT

(a) Apply a light coat of disc brake grease to both sides of the No. 1 anti-squeal shims.

(b) Install the No. 1 and No. 2 anti-squeal shims to each pad.

(d) Install the front disc brake anti-rattle spring between the 2 pads.

NOTICE:

The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.

(e) Install the 2 hole pins.

(f) Install the pin hold clip.

NOTICE:

The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.

5. BLEED BRAKE LINE

6. INSTALL FRONT WHEEL

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

See More:

Toyota Tundra Service Manual > Lighting: Footwell Light
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL FOOT LIGHT BULB (a) Install the foot light bulb. Removal REMOVAL PROCEDURE 1. REMOVE FOOT LIGHT BULB (a) Remove the foot light bulb. ...

Toyota Tundra Service Manual: Installation

Inspection

Reassembly

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual