Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL FAN

(a) Install the fan to the fluid coupling with the 4 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL FAN SHROUD

(a) Install the fan pulley to the fan bracket.

(b) Place the fan shroud together with the fluid coupling fan between the radiator and engine.

NOTICE:

Be careful not to damage the radiator core

(c) Temporarily install the fluid coupling fan to the fan bracket with the 4 nuts. Tighten the nuts as much as possible by hand.

(d) Attach the shroud's claws to the radiator as shown in the illustration.

(e) Install the shroud with the 2 bolts.

Torque:

6.5 N·m {66 kgf·cm, 58 in·lbf}

(f) Connect the reservoir hose to the upper radiator tank.

(g) Install the fan and generator V-belt (See page ).

(h) Tighten the 4 nuts of the fluid coupling fan.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

3. INSTALL INLET RADIATOR HOSE

(a) Install the inlet radiator hose.

HINT:

The direction of each hose clamp is indicated in the illustration.

4. INSTALL AIR CLEANER ASSEMBLY

5. ADD ENGINE COOLANT

6. INSPECT FOR COOLANT LEAK

7. INSTALL V-BANK COVER SUB-ASSEMBLY

8. INSTALL NO. 1 ENGINE UNDER COVER

    Inspection

    Removal

    See More:

    Toyota Tundra Service Manual > Sfi System: Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance (P2121)
    DESCRIPTION HINT: Refer to DTC P2120 (See page ). DTC No. DTC Detection Condition Trouble Area P2121 Either conditions (1) or (2) met for 0.5 seconds (1 trip detection logic): (1) Difference between VPA and VPA2 is less than 0.4 V, or more than 1.2 V. (learned value of accelerator off position) (2) ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0334