Components COMPONENTS ILLUSTRATION ![]() Inspection INSPECTION PROCEDURE 1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR ![]() (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the manifold absolute pressure sensor. Installation INSTALLATION PROCEDURE 1. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
(c) Connect the manifold absolute pressure sensor connector. 2. INSTALL V-BANK COVER SUB-ASSEMBLY Removal REMOVAL PROCEDURE 1. REMOVE V-BANK COVER SUB-ASSEMBLY 2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR (a) Disconnect the manifold absolute pressure sensor connector.
|
Toyota Tundra Service Manual > Steering Angle Sensor: Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ). 2. ...