INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the throttle body assembly (See page
PROCEDURE 1. INSTALL THROTTLE BODY ASSEMBLY HINT: Perform "Inspection After Repairs" after replacing the throttle body assembly (See page
(f) Connect the 2 water by-pass hoses. HINT: When connecting the hoses, make sure the paint marks and clips are as shown in the illustration. 2. INSTALL AIR CLEANER HOSE ASSEMBLY 3. ADD ENGINE COOLANT 4. INSPECT FOR COOLANT LEAK 5. INSTALL ENGINE UNDER COVER NO.1 6. INSTALL V-BANK COVER SUB-ASSEMBLY 7. PERFORM INITIALIZATION NOTICE: Perform the following procedure after replacing the throttle body assembly or any throttle body assembly components. The following procedure should also be performed if the throttle body assembly is cleaned. (a) Turn the ignition switch to ON without operating the accelerator pedal. NOTICE: If the accelerator pedal is operated, perform the above step again. (b) Connect the Techstream to the DLC3 and clear the DTCs (See page
(c) Perform the "Inspection After Repairs" (See page
(d) Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up. Standard:
HINT:
(e) Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more. (f) Perform a road test and confirm that there are no abnormalities. |
Toyota Tundra Service Manual > Terms: Glossary Of Sae And Toyota Terms
GLOSSARY OF SAE AND TOYOTA TERMS This glossary lists all SAE-J1930 terms and abbreviations used in this manual in compliance with SAE recommendations, as well as their TOYOTA equivalents. SAE ABBREVIATIONS SAE TERMS TOYOTA TERMS ( )-ABBREVIATIONS A/C Air Conditioning Air Conditioner ACL Air Cleaner ...