ON-VEHICLE INSPECTION PROCEDURE 1. CHECK THROTTLE BODY ASSEMBLY (a) Check the throttle control motor operating sounds. (1) Turn the ignition switch to ON. (2) When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises emit from the motor. If friction noise exists, replace the throttle body. (b) Check the throttle position sensor. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream main switch ON. (4) Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. (5) Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is within the specification. Standard throttle valve opening percentage: 60% or more HINT: When checking the standard throttle valve opening percentage, the shift lever should be in the N position. If the percentage is less than 60%, replace the throttle body assembly. |
Toyota Tundra Service Manual > Tire And Wheel System: How To Proceed With Troubleshooting
PROCEDURE 1. CHECK TIRE AND WHEEL SYSTEM DIAGNOSIS OF IRREGULAR TIRE WEAR GO TO STEP 9 DIAGNOSIS OF TIRE VIBRATION 2. TIGHTEN WHEEL NUTS NEXT 3. INSPECT TIRES Click here NG GO TO STEP 6 OK 4. INSPECT AND/OR ADJUST WHEEL BALANCE Click here NEXT 5. INSPECT FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB ...