Toyota Tundra Service Manual: Rear Crankshaft Oil Seal

Components

COMPONENTS

ILLUSTRATION

*1	DRIVE PLATE AND RING GEAR SUB-ASSEMBLY	*2	REAR CRANKSHAFT OIL SEAL
*3	CRANKSHAFT ANGLE SENSOR ROTOR	*4	REAR DRIVE PLATE SPACER
*a	BLACK: x 1 SILVER: x 5	-	-
	N*m (kgf*cm, ft.*lbf): Specified torque	●	Non-reusable part
	MP grease	★	Precoated part
*T1	1st: 30 N*m (306 kgf*cm, 22 ft.*lbf) 2nd: Turn 90°	-	-

Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR CRANKSHAFT OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge. SST: 09223-56010 NOTICE: Keep the lip free from foreign matter. Do not tap on the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

(a) for 2WD:

Refer to the following procedures (See page ).

(b) for 4WD:

Refer to the following procedures (See page ).

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

(a) for 2WD:

Refer to the following procedures (See page ).

(b) for 4WD:

Refer to the following procedures (See page ).

4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

5. REMOVE REAR CRANKSHAFT OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.

(b) Using a screwdriver, pry out the oil seal. NOTICE: Do not damage the surface of the oil seal press fit hole and crankshaft. HINT: Tape the screwdriver tip before use.