INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY NOTICE: Move the drive shaft while keeping it level.
(b) Check if the inboard joint shaft slides smoothly in the thrust direction. (c) Check if there is excessive play in the radial direction of the inboard joint shaft. (d) Check the boots for damage. |
Toyota Tundra Service Manual > Rear Door(for Crewmax): On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH (a) Check that the clearance measurements of areas A to J are within the standard range. Standard measurement: Area Specified Condition Area Specified Condition A 4.7 to 7.7 mm (0.185 to 0.303 in.) F 0.7 to 3.7 mm (0.0276 to ...
