Toyota Tundra Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

(a) Apply MP grease to a new spider and bearings.

NOTICE:

Be careful not to apply too much grease.

(b) Fit the spider to the yoke.

(c) Measure dimension A between the snap ring grooves.

(d) Insert the spider bearing into the spider journal portion, and then measure dimension B of the universal joint.

NOTICE:

When measuring dimension B, fix the spider and needle roller bearings in a vise and hold them firmly together.

(e) Select snap rings to make dimensions A and B the same. Hole Snap Ring Thickness: Color Thickness Black 1.486 mm (0.0585 in.) Copper 1.511 mm (0.0595 in.) White 1.537 mm (0.0605 in.) Yellow 1.588 mm (0.0625 in.) Blue 1.638 mm (0.0645 in.) NOTICE: Use new snap rings. If possible, use snap rings of the same thickness for both edges.

(f) Insert the spider into the flange yoke, and then using SST, press in the spider bearing into the snap ring groove. SST: 09332-25010 HINT: Press in the spider bearing on the opposite side in the same way. NOTICE: When pressing in the spider bearing, be careful not to damage its lip.

(g) Using needle-nose pliers, install new snap rings into the grooves of the yoke.

2. INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

3. INSPECT FRONT PROPELLER SHAFT ASSEMBLY

HINT:

When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration.

Rear Side

-

-