Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT STEERING COLUMN ASSEMBLY

(a) Measure the length of the steering main shaft.

Standard length (A):

529.5 mm (1.74 ft.)

(b) Inspect the bushings.

(1) Check that the 2 bushings are securely installed to the steering column assembly.

Text in Illustration

Bushing

If the bushings are missing or damaged, replace the steering column assembly with a new one.

(2) Check the 2 bushings for deformation and damage.

If the bushings are deformed or damaged, replace the steering column assembly with a new one.

(1) Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Standard Dimension:

A	B
3 mm (0.118 in.)	10 mm (0.394 in.)

Text in Illustration

Capsule

If the capsules are not positioned as specified, replace the steering column assembly with a new one.

(2) Check the 2 capsules for deformation and damage.

If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.

Toyota Tundra Service Manual > Rear View Monitor System(for Navigation Receiver Type): Reverse Signal Circuit
DESCRIPTION The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK VEHICLE SIGNAL (OP ...

Toyota Tundra Owners Manual