Toyota Tundra Service Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE COOLER COMPRESSOR BRACKET

(a) Detach the harness clamp.

(b) Remove the screw and the cooler compressor bracket.

2. REMOVE MAGNET CLUTCH ASSEMBLY

(a) Clamp the cooler compressor assembly in a vise.

(b) Using SST, hold the magnet clutch hub.

SST: 09985-00270

(c) Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.

(d) Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.

(e) Disconnect the connector.

(f) Using a snap ring expander, remove the snap ring and magnet clutch stator.

    Components

    Inspection

    See More:

    Toyota Tundra Service Manual > Rear Door(for Crewmax): Adjustment
    ADJUSTMENT CAUTION / NOTICE / HINT HINT: Before adjusting the door position for vehicles equipped with side airbags and curtain shield airbags, be sure to disconnect the battery. After adjustment, inspect the SRS warning light and check for DTC (see page ). Use the same procedures for the RH side an ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0118