Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Vehicle Interior / Air Conditioning / Compressor / Inspection

INSPECTION

PROCEDURE

1. INSPECT COOLER COMPRESSOR ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (SSR+) - 2 (SSR-)

20°C (68°F)

65 to 125 Ω
Text in Illustration

*a

Component without harness connected

(Magnet Clutch Assembly)

If the resistance is not as specified, replace the cooler compressor assembly.

2. INSPECT MAGNET CLUTCH ASSEMBLY

(a) Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.

Text in Illustration

*1

Battery

*2

Magnet Clutch Rotor

*3

Magnet Clutch Hub

*a

Component without harness connected

(Magnet Clutch Assembly)

If the operation is not as specified, replace the magnet clutch assembly.
    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Vane Pump(for 3ur-fe, 3ur-fbe): Installation
    INSTALLATION PROCEDURE 1. INSTALL VANE PUMP ASSEMBLY HINT: Before performing the following procedures, move the spacer until the vane pump can be installed. (a) Install the vane pump with the 2 bolts. Torque: 28 N·m {286 kgf·cm, 21 ft·lbf} 2. CONNECT PRESSURE FEED TUBE (a) Install a new gasket to ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0142