INSTALLATION PROCEDURE 1. INSTALL COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR
(b) Attach the 2 claws to install the cooler (room temperature sensor) thermistor. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (a) for Column Shift Type: Click here (b) for Floor Shift Type: HINT: Use the same procedure described for Column Shift Type. 3. INSTALL INSTRUMENT SIDE PANEL LH (a) for Column Shift Type: Click here (b) for Floor Shift Type: HINT: Use the same procedure described for Column Shift Type. 4. INSTALL COWL SIDE TRIM BOARD LH (a) for Double Cab: Click here (b) for CrewMax: HINT: Use the same procedure described for Double Cab. 5. INSTALL FRONT DOOR SCUFF PLATE LH (a) for Double Cab: Click here (b) for CrewMax: Click here |
Toyota Tundra Service Manual > Rear Door(for Double Cab): Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (see page ). PROCEDURE 1. INSTALL REAR DOOR WEATHERSTRIP LH (a) Attach the 34 clips ...
