Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (see page ).

2. CHECK FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (see page ).

(b) When the front bumper of the vehicle or its area is damaged, check if there is any damage to the front airbag sensor. If the front airbag sensor has defects as mentioned below, replace it with a new one:

  • Cracks, dents or chips on the sensor housing.
  • Cracks or other damage to the connector.
  • Peeling off of the label or damage to the serial number.

CAUTION:

For removal and installation procedures of the front airbag sensor, be sure to follow the correct procedure.

3. CHECK FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

(a) Replace the front airbag sensor.

CAUTION:

  • For removal and installation procedures of the front airbag sensor, be sure to follow the correct procedure.
  • If the airbags have deployed, replace the front airbag sensor on the side in which the collision occurred. Replace both if necessary.
    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Vehicle Stability Control System: Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
    CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE 1. PRE-INSPECTION (a) Brake pedal inspection (1) Perform a visual inspection and operate the brake pedal ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0093