Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the LH and RH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE BATTERY (for LH Side)

(a) Disconnect the cable from the positive (+) battery terminal.

(b) Loosen the nut, move the stay off the battery, and remove the battery.

4. REMOVE FRONT AIRBAG SENSOR

(a) Remove the nut and front airbag sensor from the body.

(b) Disconnect the connector.

    On-vehicle Inspection

    Front Passenger Airbag Assembly

    See More:

    Toyota Tundra Service Manual > Front Seat Side Airbag Assembly(for Power Seat): Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands. HINT: Use the same procedures for the LH side and RH side. PROCEDURE 1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH CAUTION: The nuts must not be reused. Make sure that t ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2023 Copyright www.ttundra.com
    0.0108