Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.

2. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:

  • Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.
  • Cracks or other damage to the connector.
  • Deformation or cracks on the instrument panel reinforcement.

CAUTION:

For removal and installation procedures of the lower No. 2 instrument panel airbag, be sure to follow the correct procedure.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Lumbar Support Adjuster Assembly: Inspection
    INSPECTION PROCEDURE 1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Seat Position Memory System) (a) Check the operation of the lumbar support adjuster assembly LH. (1) Apply battery voltage to the lumbar support motor LH connector, and check that the lumbar support adjuster assembly LH operates ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0353