INSTALLATION PROCEDURE 1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY) (a) Connect the connector. (b) Install the trailer brake control switch with the 2 bolts. Torque: xx N*m (xx kgf*cm, xx in.*lbf) 2. INSTALL NO. 2 SWITCH HOLE BASE 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 4. INSTALL COWL SIDE TRIM BOARD LH 5. INSTALL FRONT DOOR SCUFF PLATE LH
6. INSTALL INSTRUMENT SIDE PANEL LH
|
Toyota Tundra Service Manual > Meter / Gauge System: Entire Combination Meter does not Operate
DESCRIPTION This circuit is the power source circuit for the combination meter assembly. This circuit provides 2 power source types: one is a constant power source mainly used as a backup power source, and other is a power source mainly used for signal transmission. The constant power source is main ...
