Toyota Tundra Service Manual: Disassembly

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Fuel / Fuel Pump / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE FUEL SENDER GAUGE ASSEMBLY

2. REMOVE SUB TANK

(a) Disconnect the fuel pump connector.

(b) Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps.

(c) Disconnect the fuel tube.

(d) Using a screwdriver, detach the 3 claws from the claw holes.

HINT:

Tape the screwdriver tip before use.

(e) Using a screwdriver, detach the 2 claws from the claw holes and remove the sub tank.

HINT:

Tape the screwdriver tip before use.

NOTICE:

Do not damage the fuel sub tank.

3. REMOVE FUEL PUMP

(a) Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the suction plate with filter.

HINT:

Tape the screwdriver tip before use.

(b) Remove the fuel pump harness.

(c) Remove the O-ring and spacer from the fuel pump.
    Components

    Inspection

    See More:

    Toyota Tundra Service Manual > Navigation System: Precaution
    PRECAUTION 1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0282