Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL PUMP

(a) Inspect the resistance of the fuel pump.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

0.2 to 3.0 Ω

If the result is not as specified, replace the fuel pump.

(b) Inspect the operation of the fuel pump.

(1) Connect the battery's positive (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

NOTICE:

  • These tests must be performed within 10 seconds to prevent the coil from burning out.
  • Keep the fuel pump as far away from the battery as possible.
  • Always turn the voltage on and off on the battery side, not the fuel pump side.

If the result is not as specified, replace the fuel pump.

    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Sfi System: Evaporative Emission Control System Leak Detected (Gross Leak) (P0455,P0456)
    DTC SUMMARY DTC No. Monitoring Item Malfunction Detection Condition Trouble Area Detection Timing Detection Logic P0455 EVAP gross leak Leak detection pump creates negative pressure (vacuum) in EVAP system and EVAP system pressure measured. Reference pressure measured at start and at end of leak che ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0095