Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • Wear protective gloves when removing the exhaust pipe assembly.
  • The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  • Confirm that the exhaust pipe assembly has cooled down before removing it.

PROCEDURE

1. REMOVE HEATED OXYGEN SENSOR

(See page )

2. REMOVE TAILPIPE ASSEMBLY

(a) Remove the bolt and clamp.

(b) Disconnect the exhaust pipe support to remove the tailpipe assembly.

(c) Remove the gasket.

3. REMOVE CENTER EXHAUST PIPE ASSEMBLY

(a) Remove the 4 bolts.

(b) Disconnect the 3 exhaust pipe supports to remove the center exhaust pipe assembly.

(c) Remove the 2 gaskets.

4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the 3 nuts and front exhaust pipe assembly.

(b) Remove the gasket.

5. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

(a) Remove the 3 nuts.

(b) Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly.

(c) Remove the gasket.

7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

    Reassembly

    1ur-fe Fuel

    See More:

    Toyota Tundra Service Manual > Center Airbag Sensor Assembly(for Floor Shift Type): Installation
    INSTALLATION PROCEDURE 1. INSTALL AIRBAG SENSOR ASSEMBLY (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the S ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0328